Yamaha RX-V1900BL User Manual

■ Using the internal amplifiers of this unit

If you want to use one internal amplifier (SP1 or SP2) of this unit
Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and set “AMP” to “[SP1]” or “[SP2]” 
(page 85).

If you want to use two internal amplifiers (SP1 and SP2) of this unit
Connect the Zone 2 and Zone 3 speakers directly to the SP1 and SP2 speaker terminals and set “AMP” to “BOTH” 
(page 85).

You can select the zone you want to control by using the 
control buttons on the front panel or on the remote control. 

■ Basic operation

Press P

ZONE 2 or PZONE 3 on the front 

Press P

ZONE CONTROLS on the front 

Each time you press PZONE CONTROLS, the 
front panel display changes as shown below, and the 
indicator for the currently selected zone flashes for 
approximately 10 seconds. However, no indicator 
flashes when the main zone is selected.

ZONE2
Controls the Zone 2 amplifier or tuner functions.

ZONE3
Controls the Zone 3 amplifier or tuner functions.

y

You must complete this step within 10 seconds while the 
selected zone flashes in the front panel display. Otherwise, 
the currently selected zone mode is automatically 
canceled.

y

To turn off the desired zone, press 

PZONE 2 or PZONE 

3 again.

Press G

ZONE repeatedly to select the zone 

you want to control.
“MAIN”, “ZONE 2”, or “ZONE 3” indicator appears 
in the display window (4) on the remote control.

The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or 
more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low 
impedance load resulting in amplifier damage. See this owner’s manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This 
information is found on the back panel of your Receiver.

R

L

R

L
+

R

L