Yamaha RX-V1900BL User Manual

Use this feature to manually adjust the basic speaker 
settings. Most of the “SPEAKER MENU” parameters are 
set automatically when you run the automatic setup.

y

• Set “TEST TONE” to “ON” (page 77) to output the test tone for 

the “CONFIG”, “LEVEL” and “DISTANCE” settings.

• If your subwoofer can adjust the output volume and the 

crossover frequency, set the volume to about half way (or 
slightly less) and set the crossover frequency to the maximum.

■ Speaker configurations A)CONFIG

LFE/BASS OUT

Use this feature to select the speakers that output the LFE 
(low-frequency effect) and the low-frequency signals.

*1 Output(s) the low-frequency signals of the front 

channels and other speakers set to “SMALL”.

*2 Always output the low-frequency signals of the front 

channels.

*3 Output the low-frequency signals if the speakers are set 

to “LARGE”.

*4 Outputs the low-frequency signals of the speakers set to 

“SMALL”.

FRONT SP

When “LFE/BASS OUT” is set to “FRONT”, you can select 
only “LARGE” in “FRONT SP”. If the value of “FRONT SP” is 
set to other than “LARGE” in advance, this unit change the 
value to “LARGE” automatically.

CENTER SP

SUR. L/R SP

Output

No output

No output

SWFR

Output

No output

No output

FRONT

No output

Output

No output

*1

*2

*3

SWFR

*4

*3

*3

FRONT

No output

*1

*3

Measure for the speaker size
The woofer section of a speaker is

– 16 cm (6.5 in) or larger: large
– smaller than 16 cm (6.5 in): small

Select this setting when the front speakers are 
large.

SMALL

Select this setting when the front speakers are 
small.

LARGE

Select this setting when the center speaker is 
large.

Select this setting when the center speaker is 
small.

NONE

Select this setting when you do not use the center 
speaker. The center channel signals are directed 
to the front left and right speakers.

LARGE

Select this setting when the surround speakers 
are large.

Select this setting when the surround speakers 
are small.

NONE

Select this setting when you do not use the 
surround speakers. This unit is set to the Virtual 
CINEMA DSP mode (page 44), and “SUR.B L/
R SP” is automatically set to “NONE”.