Yamaha YSP-1 User Manual

In addition to controlling this unit, the remote control can also operate other A/V components made by YAMAHA and 
other manufacturers. To control other components, you must set up the remote control with the appropriate remote 
control codes.

Depending on the external AV component you are using, you may not be able to operate the component with this unit’s remote control, 
even if a remote control code is set. In this case, operate the component using the supplied remote control.

You can control other components by setting the 
appropriate remote control codes. Codes can be set up for 
each input area (TV, DVD, VCR and AUX).
For a complete list of available remote control codes, refer 
to “LIST OF REMOTE CONTROL CODES” at the end of 
this manual.

 

Refer to “LIST OF REMOTE CONTROL CODES” 
at the end of this manual.

Refer to “Controlling other components” on 
page 52 to operate the external component 
using this unit’s remote control.

If the external component functions correctly, remote 
control code setup was successful.
If the external component does not function correctly, 
the remote control code may be incorrect. Confirm 
that the remote control code is correct (see “LIST OF 
REMOTE CONTROL CODES” at the end of this 
manual) and start over from step 1.

If the manufacturer of your component has more than one code, 
try each of them until you find the correct one.

If the remote control is without batteries for more than 
2 minutes, or if exhausted batteries remain in the 
remote control, the contents of the memory may be 
cleared. When the memory is cleared, insert new 
batteries and reset the remote control codes.
When changing the batteries, be careful not to press 
any of the buttons on the remote control. Doing so will 
clear the contents of the memory.