Yamaha RX-Z7 User Manual

Use the supplied simplified remote control to make basic controls of this unit.

■ Setting the controlling zone of the 

Use this feature to set the controlling zone (page 127) and 
remote control ID (page 130) of the simplified remote 
control.

Setting the remote control ID
• ID1: Press and hold l (left cursor) and 1 for 3 

seconds.

• ID2: Press and hold l (left cursor) and 2 for 3 

seconds.

Setting the controlling zone
• Main zone: Press and hold h (right cursor) and 1 for 3 

seconds.

• Zone 2: Press and hold h (right cursor) and 2 for 3 

seconds.

• Zone 3: Press and hold h (right cursor) and 3 for 3 

seconds.

• Zone 4: Press and hold h (right cursor) and 4 for 3 

seconds.

■ Replacing the battery in the simplified 

Change the battery when the operation range of the 
simplified remote control decreases.

• Insert the battery according to the polarity markings 

(+ and –).

• If the batteries run out, immediately remove them from the 

simplified remote control to prevent an explosion or acid leak.

• If a battery starts leaking, dispose of it immediately. Be careful 

not to let the leaking battery acid touch your skin or clothing.

• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.

STANDBY
Sets the selected zone to the 
standby mode.

SYSTEM MEMORY
Save or recall the system 
settings.

INPUTl / h
Select the input source.

POWER
Turn on the power.

VOLUME +/–
Adjust the volume level.

MUTE
Mutes the audio output.

Remove the insulation sheet before using the remote 
control.

These buttons function as 
well as the following 
identical buttons on the 
main remote control (when 
the operation selector mode 
is set to FAMP).
8STATUS
9

k / n / l / h

9ENTER
0RETURN, SUBMENU
IMENU
KDISPLAY