Yamaha RX-V2400 User Manual

1

Turns on this unit or sets it to the standby mode. When you 
turn on this unit, you will hear a click and there will be a 4 
to 5-second delay before this unit can reproduce sound.

In standby mode, this unit consumes a small amount of power in 
order to receive infrared-signals from the remote control.

2

Selects the input source you want to listen to or watch.

3

Receives signals from the remote control.

4

Shows information about the operational status of this 
unit.

5

Switches the function of PRESET/TUNING l / h 
between selecting preset station numbers and tuning.

6

Switches the reception band between FM and AM.

7

Stores a station in the memory. Hold down this button for 
more than 3 seconds to start automatic preset tuning.

8

Switches the tuning mode between automatic (“AUTO” 
indicator on) and manual (“AUTO” indicator off).

9

Controls the output level of all audio channels.
This does not affect the REC OUT level.

0

Turn on or off the set of front speakers connected to the A 
and/or B terminals on the rear panel at each time the 
corresponding button is pressed.

A

Selects the source connected to the MULTI CH INPUT 
jacks. When selected, the MULTI CH INPUT source takes 
priority over the source selected with INPUT (or the input 
selector buttons on the remote control).

B

Sets the priority (AUTO, DTS, ANALOG) for the type of 
signals received when one component is connected to two 
or more of this unit’s input jacks (see page 34). Priority 
cannot be set when MULTI CH INPUT is selected as the 
input source.

1

2

4

9

0

A B

D E F

C

G

H

K

J

I

M N O

L

3

6 7 8

5

00_RX-V2400U_EN.book  Page 4  Friday, October 10, 2003  10:54 AM