Yamaha X-V2600 User Manual

Use this feature to reassign digital input/outputs, select the 
input signal, rename the inputs, or adjust the level of the 
signal input at each jack.

Choices: XM, TUNER, PHONO, CD, CD-R, MD/TAPE, 

DVD, DTV, CBL/SAT, VCR1, DVR/VCR2, 
V-AUX, MULTI CH

Some parameters described below may not be available for all 
input sources and some parameters are only available for specific 
input sources.

Set AMP/SOURCE/TV to AMP and then press 
GUI TOP on the remote control.
The top display appears.

Select Input Select and then press h.

Select the desired input source (CD, DVD, 
etc.) and then press h to access and adjust.

■ Antenna Level (Antenna level)

Use to display the XM Satellite Radio reception level.

Input Select > XM > Antenna Level >
Display status: NONE, 0 to 100%

• If the displayed percentage of the reception level is 

below the average (approximately 60%), you need to 
adjust the orientation of the XM Satellite Radio 
antenna for a better percentage of the reception level.

• If NONE is displayed, the XM Satellite Radio antenna 

may not be firmly connected to the XM jack on the rear 
panel of this unit. Check the XM Satellite Radio 
connection.

The Antenna Level parameter cannot be adjusted by using the 
remote control. Instead, you need to adjust the orientation of the 
XM Satellite Radio antenna for a better percentage of the 
reception level.

XM

Antenna Level
Volume Trim
Rename

TUNER

Volume Trim
Rename

PHONO

CD

CD-R

MD/TAPE

DVD
DTV

CBL/SAT

VCR1

DVR/VCR2

 I/O Assignment
Audio Select
Decoder Mode
Volume Trim
Rename

V-AUX

Audio Select
Decoder Mode
Volume Trim
Rename

MULTI CH

Volume Trim
Multi CH Assign