Yamaha RX-V630RDS User Manual
17
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC OPERA-
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
CONNECTIONS
D-TV
/CBL
/CBL
DVD
FM
ANT
AM
ANT
GND
75 UNBAL.
VIDEO
R OUT
MONIT
OUT
VIDEO
EO
TUNER
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
Indoor FM
antenna
(included)
antenna
(included)
AM loop antenna
(included)
Connecting the antennas
RX-V630RDS
11 (7/16)
8 (5/16)
6 (1/14)
6 (1/14)
■ Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and
GND terminals.
antenna lead wires into the AM ANT and
GND terminals.
3
Orient the AM loop antenna for the best
reception.
reception.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
included 75-ohm/300-ohm
antenna adapter.
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
of the 75-ohm coaxial
cable and prepare it for
connection.
Cut the lead wire and
remove it.
remove it.
Insert the cable wire into the
slot, and clamp it with pliers.
slot, and clamp it with pliers.
Snap the cover into
place.
place.
1
2
Unit:
mm (inch)
mm (inch)
3
Lead wire
4
Clamp with
pliers.
pliers.
Clamp
with
pliers.
with
pliers.
Insert the wire
into the slot.
into the slot.
5
Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength.
unit. In general, these antennas should provide sufficient
signal strength.
Connect each antenna correctly to the designated
terminals.
terminals.
75-ohm/300-ohm antenna adapter (U.K. model)
0103V630_9-18_EN(GB)
1/11/02, 7:40 PM
17