Yamaha D5000 User Manual

Your recorded sample may contain silence or otherwise unneeded sounds at either the beginning 
or end. Use the 

START

 and 

END

 parameters to move the playback points to tailor the sample to your 

needs. If you set the 

END

 parameter to a lower value than the 

START

 parameter, the sample will be 

played in reverse.

Press the 

[ DELAY ] key again to switch to the second page of the FREEZE 

program.

Use the 

[ ^ ] and [ % ] CURSOR keys to move through the various 

parameters. Modify the selected parameter by rotating the DATA ENTRY 
encoder.

MODE

 (

MOMENTARY

/

CONTINU.

/

INPUT TRG

)

Select the playback mode.

MOMENTARY

The playback loop is activated while you press 
the 

[ TRIGGER ] key or step on a footswitch 

connected to the TRIGGER Footswitch Jack, or 
when a MIDI Note On message is received. 
Playback stops when you release the 

[ TRIGGER ] 

key or footswitch, or a Note Off message is 
received.

CONTINU.

Playback starts while you press the 

[ TRIGGER ] 

key or step on a footswitch connected to the 
TRIGGER Footswitch Jack, or when a MIDI Note 
On message is received. Playback continues for 
the specified number of loops. To stop playback 
immediately, press the 

[ TRIGGER ] key or step on 

the footswitch again.

INPUT TRG

When the input level is higher than a specified 
threshold, the D5000 will playback the data the 
specified number of times.

START

 (ms)

Select the start point of the playback. For stereo, select a value 
between 0.00 and 5200.00. For mono, select a value between 0.00 
and 10400.00.

END

 (ms)

Select the end point of the playback. See above for the parameter 
values.

LOOP

 (ms)

Set the loop point. See above for the parameter values.

NUMBER

 (0 ~ 100)

Set the number of loops for the 

CONTINU.

 and 

INPUT TRG

 

modes. This parameter does not appear on the LCD in 

MOMENTARY

 mode.

TRG.MASK

 (0 ~ 1000 ms)

Set a delay that must elapse before the playback loop can be 
triggered. This parameter only appears when 

INPUT TRG

 mode 

is set.