Yamaha HTR-6060 User Manual

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid 
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied 
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening 
environment.

• Be advised that it is normal for loud test tones to be output 

during the “AUTO SETUP” procedure.

• To achieve the best results, make sure the room is as quiet as 

possible while the “AUTO SETUP” procedure is in progress. If 
there is too much ambient noise, the results may not be 
satisfactory.

y

• You can run “AUTO SETUP” using the system menu that 

appears in the OSD or in the front panel display. This manual 
uses the OSD illustrations to explain the “AUTO SETUP” 
procedure.

• Before performing operations, set the operation mode selector 

on the remote control to KAMP.

• This unit uses the speakers connected to the FRONT A speaker 

terminals as the front speakers for the adjustment.

Make sure of the following check points 
before starting the AUTO SETUP operations.
❏ Speakers are connected appropriately.

❏ Headphones are disconnected from this unit.

❏ This unit and the video monitor are turned on.

❏ The connected subwoofer is turned on and the 

volume level is set to about half way (or slightly 
less).

❏ The crossover frequency controls of the 

connected subwoofer is set to the maximum.

❏ The room is sufficiently quiet.

The following menu screen appears on the video 
monitor.

y

It is recommended that you use a tripod (etc.) to affix the 
optimizer microphone at the same height as your ears would be 
when you are seated in your listening position. You can use the 
attached screw of a tripod (etc.) to fix the optimizer microphone 
to the tripod (etc.).

AUTO:MENU

PRESENCENONE   

. EXTRASPASSIGN

>FRONTB

SETUP

;;;;;;;AUTO

EQ

;;;;;;;NATURAL

START

[ ]/[ ]:Up/Down
[]/[]:Select

[

[

[

[