Yamaha HTR-5940 User Manual

  BASS OUT

Use this feature to select the speakers that output the LFE 
(low-frequency effect) and the low-frequency signals.
Choices: SWFR, FRNT, BOTH
• Select “SWFR” (subwoofer) if you connected a 

subwoofer. The LFE signals as well as the low-
frequency signals of other speakers set to “SML” 
(or “SMALL”) or to “NONE” are directed to the 
subwoofer.

• Select “FRNT” (front) if you did not connect a 

subwoofer. The LFE signals, the low-frequency signals 
of the front left and right channels, and the low-
frequency signals of other speakers set to “SML” or to 
“NONE” are all directed to the front left and right 
speakers regardless of the “FRONT” setting (see 
page 78).

• Select “BOTH” (both) if you connected a subwoofer. 

The low-frequency signals of any source are output 
from the subwoofer. The LFE signals as well as the 
low-frequency signals of other speakers set to “SML” 
or to “NONE” are directed to the subwoofer. The low-
frequency signals of the front left and right channels 
are directed to the front left and right speakers 
regardless of the “FRONT” setting (see page 78).

  CROSSOVER

Use this feature to select a crossover frequency of all the 
speakers set to “SML” (or “SMALL”) or to “NONE” in 
“SPEAKER SET” (see page 78). All frequencies below 
the selected frequency will be sent to the subwoofer or to 
the speakers set to “LRG” (or “LARGE”) in “SPEAKER 
SET” (see page 78).
Choices: 40Hz, 60Hz, 80Hz, 90Hz, 100Hz, 110Hz, 

120Hz, 160Hz, 200Hz

  SWFR PHASE

Use this feature to switch the phase of your subwoofer if 
bass sounds are lacking or unclear.
Choices: NRM, REV

• Select “NRM” if you do not want to reverse the phase 

of your subwoofer.

• Select “REV” to reverse the phase of your subwoofer.

■ Speaker level  B) SP LEVEL
Use this feature to manually balance the speaker levels 
between the front left or surround left speakers and each 
speaker selected in “SPEAKER SET” (see page 78). The 
selected speaker outputs test tone and the speaker 
indicator of the speaker flashes.

Control range: –10.0 to +10.0 dB
Control step: 1.0 dB
Initial setting: 0 dB

The following is an example where “FL” is selected to 
adjust the balance of the front left speaker.

• Select “FL” to adjust the balance of the front left 

speaker.

• Select “FR” to adjust the balance of the front right 

speaker.

• Select “C” to adjust the balance of the center speaker.
• Select “SL” to adjust the balance of the surround left 

speaker.

• Select “SR” to adjust the balance of the surround right 

speaker.

• Select “SB” to adjust the balance of the surround back 

speaker.

• Select “SWFR” to adjust the balance of the subwoofer.

“C”, “SL”, “SR”, “SB” and “SWFR” cannot be adjusted if 
“CENTER” (see page 78), “SUR. LR” (see page 78), “SUR. B” 
(see page 78) and “BASS OUT” (see page 79) are set to “NONE” 
respectively.

pDVD

FL ----||----