Kenwood VR-8050 User Manual

1 Use the Input Selector keys to select the source (other than “MD/

2 Set the MD or TAPE recorder to record.

3 Start playback, then start recording.

1 Use the Input selector keys to select the video source (other than

2 Set the video deck connected to VIDEO 1 to record.

• Select the REC MODE to record a digital input source.

3 Start playback, then start recording.

• Recording may not be normal for some video software. This is due

to the copy guard condition.

w

Switch on the REC MODE to record a digital input source.
Usually use the REC MODE AUTO to record audio input sources. When
the digital mode changes during recording in the REC MODE AUTO, the
audio input source may be interrupted momentarily.

1 Use the Input Selector keys to select the source (CD/DVD,

2 Set the MD or TAPE recorder to record.

3 Press and hold the DIMMER key for more than 2 seconds to

1 REC MODE off

: The digital input record mode is

switched off.

2 REC MODE AUTO

: The digital input signals (DTS, Dolby

Digital, or PCM) are identified auto-
matically and converted into stereo
signals that are ready for recording.

3 REC MODE MANUAL : The input signal type at the moment

this mode is selected is held through-
out this mode.

• When the REC MODE MANUAL is selected, the digital input signal

is converted to stereo signals (down-mix). But once the digital signal
is changed to other signal, no signal is output.
When the REC MODE AUTO  is selected, the digital input signal is
converted to stereo signals even if the digital signal is changed.

4 Start playback, then start recording.

• If the audio reproduction stops in the middle due to change in the

input signals, etc., press the DIMMER key.

*5458/17-25/EN

04.3.5, 0:14 PM

23