Integra DHC-9.9 User Manual

127

Power Control
To link the power functions of 

-compatible 

components connected via HDMI, select “Enable”.

Notes:
• The “Power Control” setting can be set only when the 

above “Control” setting is set to “Enable”.

• HDMI power control only works with 

-com-

patible components that support it and may not work 
properly with some components due to their settings 
or compatibility.

• When set to “Enable”, power consumption will 

increase.

• Refer to the connected component’s instruction man-

ual for details.

TV Control
Set to “Enable” when you want to control the AV con-
troller from an 

-compatible TV that is con-

nected to HDMI.

Notes:
• Set  to  “Disable” when the TV is not compatible or 

when it is unclear whether the TV is compatible or 
not.

• The “TV Control” setting can be set only when the 

above “Control” and “Power Control” settings are both 
set to “Enable”.

• Refer to the connected component’s instruction man-

ual for details.

Note:
When modifying network settings, after modifying it is 
necessary to execute 

 Save Settings.

This section explains how to configure the AV control-
ler’s network settings manually.
If your router’s DHCP server is enabled, you don’t need 
to change any of these settings, as the AV controller is set 
use DHCP to configure itself automatically by default 
(i.e., DHCP is set to Enable). If, however, your router’s 
DHCP server is disabled, for example, you’re using 
static IP addresses, you’ll need to configure these set-
tings yourself, in which case, a knowledge of Ethernet 
networking is essential.

DHCP (Dynamic Host Configuration Protocol) is used 
by routers, computers, the AV controller, and other 
devices to automatically configure themselves on a net-
work.

Disable: Power Control disabled.

Enable: Power Control enabled.

Disable: TV Control disabled.

Enable: TV Control enabled.

Note:
After changing the settings of the “Control”, “Power 
Control”

, or “TV Control”, turn off the power to all 

connected pieces of equipment and then turn on 
again. Refer to the User’s Manuals for all connected 
pieces of equipment.
When linking to a TV that conforms to the CEC 
standard, the “Monitor Out” setting must be set to 
“HDMI Main”.

Press the [Receiver] Remote 
Mode button, followed by the 
[Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] but-

tons to select “7. Hardware 
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.

Receiver

Setu

p

Enter

Enter