Integra DHC-9.9 User Manual

Press [Enter].
The automatic speaker setup starts.

Test tones are played through each
speaker as Audyssey MultEQ

Automatic Speaker Setup runs. This
process takes a few minutes. Please
refrain from talking during
measurements and do not stand
between speakers and the microphone.

The speaker detect results
appear.

“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.

If you agree with the results, use
the Up and Down [

q]/[w] buttons

to select “Next”, and then press
[Enter].
The options are:

Next: Proceed to the next step.

Retry: Return to step 2 and try again.

Cancel: Cancel the automatic speaker

setup.

Enter

Auto Speaker Setup

Do not unplug Setup Mic.

Please keep quiet.

Now measuring. . .

Enter

Auto Speaker Setup

Speaker Detect Result

Next
Retry
Cancel

ENTER

MOVE

:Yes

:No

The following screen appears.

Place the setup microphone at
the next position (see page 58),
and then press [Enter].
Audyssey MultEQ

XT performs more

measurements. This takes a few minutes.

When prompted, place the setup
microphone at the next position,
and repeat step 5.

After the 3rd or 7th measure-
ment, the following screen
appears.

Use the Up and Down [

q]/[w] but-

tons to select an option, and then
press [Enter].

Next:

Select “Next” to begin measuring
the next measurement position.
After the 8th measurement has been
taken, the procedure automatically
proceeds to step 8.

Finish(Calculate):

Select this if you don’t want to
measure any more listening posi-
tions and are ready to calculate the
results, then go to step 8.

Auto Speaker Setup

Please place microphone at next position at ear height.

Next

ENTER

Enter

Auto Speaker Setup

Do not unplug Setup Mic.

Please keep quiet.

Now measuring. . .

Enter

Auto Speaker Setup

Select [Next] to measure the next position, or select
[Finish] to calculate the Audyssey MultEQ room EQ
solution.

Next
Finish(Calculate )

ENTER

MOVE