Kenwood KR-897 User Manual
KR-897/KR-797 (En)
18
Recording
To record a music source
1 Select the source to be recorded.
Copying tape (Tape dubbing TAPE 2
= TAPE 1)
The input sources are switched in the following order:
1 TUNER (frequency display)
2 PHONO
3 TAPE1 (MD or VIDEO1)
4 CD
5 VIDEO2
2 PHONO
3 TAPE1 (MD or VIDEO1)
4 CD
5 VIDEO2
INPUT SELECTOR
2 Select a source other than TAPE 1.
TUNING
BAND DISPLAY
TAPE2
MONITOR
INPUT SELECTOR
C D
TAPE 2
Lights
÷ For copying a tape using a double cassette deck, read the instruction
manual of the double cassette deck.
Copying tape (Tape dubbing TAPE 1
= TAPE 2)
1 Select TAPE 1 with the INPUT SELECTOR control of the
main unit.
2 Play the cassette deck connected to the TAPE 1 jacks and
start recording of the cassette deck connected to the
TAPE 2 jacks.
TAPE 2 jacks.
1 Press the TAPE 2 MONITOR key.
3 Play cassette deck 2 and start recording
on cassette deck 1.
When recording sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR
to select TAPE1 or MD according to the connected component.
to select TAPE1 or MD according to the connected component.
Regarding TAPE 2 MONITOR
A cassette deck or graphic equalizer can be connected to this unit’s TAPE 2 MONITOR terminals. If you connect a graphic equalizer, turn the
TAPE 2 MONITOR key ON. If you connect a 3-head cassette deck, you can monitor the source sound, or the sound being recorded, while
recording. Pressing the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for
the component you connected for further details.
TAPE 2 MONITOR key ON. If you connect a 3-head cassette deck, you can monitor the source sound, or the sound being recorded, while
recording. Pressing the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for
the component you connected for further details.
Preparation
÷ Switch the TAPE1 display to MD or VIDEO1 with the following
operation.
1 Select TAPE1 with the INPUT SELECTOR.
2 Press and hold the AUTO key for more than 2 seconds.
Select an input
source other than
TAPE 1.
source other than
TAPE 1.
2 Put the cassette deck in record-pause
mode.
3 Play the source and start recording.
3
VIDEO1
2
MD
1
TAPE1
Each press switches the display.
÷ The VIDEO1 display can be switched to the display of other input by
using the procedure described in “Preparation” above.
÷ For the synchro recording with a cassette deck and/or MD recorder,
refer to the respective instruction manuals..
÷ It is not possible the VIDEO1 or MD input to TAPE1 because all of these
components should use the same INPUT SELECTOR position.
KR-897_797(En).pm5
07.6.11, 5:06 PM
18