ICOM IC PCR100 User Manual

32

5

SCAN OPERATION

■

When receiving a signal, scan automatically pauses on that
signal. The scan resume condition sets the time that the scan
pauses before resuming or whether scan stops instead of
pausing.

q

Call up the setting screen if it is not displayed.

• For the multi-function receiver screen, click the [SET] button.
• For the simple function receiver screen, click the [MENU] button

and select the ‘Function Setting (SET).’ When the scan controller
screen is in use, click the [SET] button on the screen.

w

Click the [SCAN Delay] tab, then click to select a resume
condition from [DELAY Timing].

(a) ‘Pause until Signal disappears’
Scan pauses when receiving a signal and remains
paused until the signal disappears.

(b) ‘Delay Volume’
When setting a delay time using the [DELAY] control
(multi-function receiver screen) or [DELAY] scroll bar
(scan controller screen), scan pauses when receiving a
signal and then resumes after the specified delay.

(c) ‘SCAN Stop’
When a signal is received during scan, scan stops and
does not resume.

e

Click to select a restart delay time from [Restart Delay].
This setting is valid when selecting (a) or (b) above.

(a) 0 Sec.
Scan resumes immediately after the signal disappears.
(b) 1 Sec.
Scan resumes 1 sec. after the signal disappears.
(c) 2 Sec.
Scan resumes 2 sec. after the signal disappears.

r

Click the close ([

"

]) button to close the setting screen.

[DELAY]

[DELAY]