ONKYO tx-nr545 User Manual

Advanced Settings (Setup Menu)

Allows you to change the speaker configuration such as presence or not of subwoofer, 

crossover frequency, and so on. Settings are automatically configured if you use the 

Automatic Speaker Setup.

This setting cannot be selected if headphones are connected or audio is output from the 

speakers of the TV.

You can change the number of speaker channels connected, the type of front speaker 

connection, the height speaker type, and other speaker settings.

Speaker Channels 7.1 ch

Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1 ch", 

"7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or 

"5.1.2 ch" to suit the number of speaker channels 

connected.

Subwoofer

Yes

Set whether a subwoofer is connected or not.

"Yes": When subwoofer is connected

"No": When subwoofer is not connected

Height Speaker

Front High

Set the speaker type if height speakers are 

connected to the BACK or HEIGHT terminals.

Select "Front High", "Top Front", "Top Middle", "Top 

Rear", "Rear High", "Dolby Speaker (Front)", or 

"Dolby Speaker (Surr)" according to the connected 

speaker type and location.

● If an item cannot be selected even though 

connection is correct, check that the settings 

in "Speaker Channels" matches the number of 

connected channels.

Bi-Amp

No

Set whether your front speaker connection is bi-

amp.

"No": When front speakers are connected in a 

normal manner

"Yes": When front speakers are bi-amp connected

● If an item cannot be selected even though 

connection is correct, check that the settings 

in "Speaker Channels" matches the number of 

connected channels.

Powered Zone 2

No

Set the connection of speakers to Zone 2 speaker 

terminals.

"Yes": When speakers are connected to ZONE2 

speaker terminals

"No": When speakers are not connected to ZONE2 

speaker terminals

● This item will be set to "No" when "Bi-Amp" is set 

to "Yes".

Allows you to change speaker configurations, such as crossover frequency. Settings are 

automatically configured if you use the Automatic Speaker Setup. Audio will not be output 

while you are making this setting.

Front

100 Hz

Select the crossover frequency from "40Hz" to 

"200Hz" to start outputting frequencies for each 

channel.

"Full Band": Full band will be output.

● If "Configuration" - "Subwoofer" is set to "No", 

"Front" will be fixed to "Full Band" and the low 

pitched range of the other channels will be output 

from the front speakers. Refer to the instruction 

manual of your speakers to make the setting.

Center

100 Hz

Select the crossover frequency from "40Hz" to 

"200Hz" to start outputting frequencies for each 

channel.

"Full Band": Full band will be output.

● "Full Band" can be selected only when "Front" is 

set to "Full Band".

● If an item cannot be selected even though 

connection is correct, check that the settings in 

"Configuration" - "Speaker Channels" matches 

the number of connected channels.