ONKYO 29400095 User Guide

81

■ Zoom Mode (Zoom)
This setting determines the aspect ratio that will be used 
for 480i and 480p input signals when they are output by 
the HDMI OUT. This setting only applies when the 
HDMI Output Resolution setting is set to 1080i or 720p.

■ Brightness
With this setting you can adjust the picture brightness.
Can be adjusted from –20 to +20 in steps of 1 (default 
is 0).

“–20” is the darkest.
“+20” is the brightest.

■ Contrast
With this setting you can adjust Contrast. 
Can be adjusted from –20 to +20 in steps of 1 (default 
is 0).

“–20” is the least.
“+20” is the greatest.

■ Hue
With this setting you can adjust the red/green balance.
Can be adjusted from –20 to +20 in steps of 1 (default is 
0).

“–20” is the strongest green.
“+20” is the strongest red.

■ Saturation
With this setting you can adjust saturation. 
Can be adjusted from –20 to +20 in steps of 1 (default 
is 0).

“–20” is the weakest color.
“+20” is the strongest color.

■ Sharpness
With this setting you can adjust sharpness.
Can be adjusted from 0 to +5 in steps of 1 (default is 0).

“0” is the default.
“+5” is the sharpest.

The digital input signal formats are available only for the 
input sources that you have assigned a digital input jack 
(see page 41).
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you 
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut 

off, try setting the format to PCM.

• If noise is produced when fast forwarding or reversing 

a DTS CD, try setting the format to DTS.

• The setting is stored individually for each input selec-

tor.

e]/[r] 

PCM:
Only 2-channel PCM format input signals will be 
heard. If the input signal is not PCM, the PCM 
indicator will flash and noise may also be pro-
duced.

DTS:
Only DTS (but not DTS-HD) format input sig-
nals will be heard. If the input signal is not DTS, 
the DTS indicator will flash and there will be no 
sound.

Auto (default): 
The format is detected automatically. If no digital 
input signal is present, the corresponding analog 
input is used instead.