Manualsbrain.com
  1. Manuals
  2. Brands
  3. ONKYO
  4. 29400021
  5. User Manual

ONKYO 29400021 User Manual

Download
Page of 148
113
Note:
When modifying network settings, after modifying it is 
necessary to execute “Save”.
This section explains how to configure the AV receiver’s 
network settings manually.
If your router’s DHCP server is enabled, you don’t need 
to change any of these settings, as the AV receiver is set 
use DHCP to configure itself automatically by default 
(i.e., DHCP is set to Enable). If, however, your router’s 
DHCP server is disabled, for example, you’re using 
static IP addresses, you’ll need to configure these set-
tings yourself, in which case, a knowledge of Ethernet 
networking is essential.
What’s DHCP?
DHCP (Dynamic Host Configuration Protocol) is used 
by routers, computers, the AV receiver, and other 
devices to automatically configure themselves on a net-
work.
What’s DNS?
The DNS (Domain Name System) translates domain 
names into IP addresses. For example, when you enter a 
domain name such as www.onkyousa.com in your Web 
browser, before accessing the site, your browser uses 
DNS to translate this into an IP address, in this case 
63.148.251.142.
Note:
This procedure can also be performed on the AV receiver 
by using its [SETUP] button, arrow buttons, and 
[ENTER] button.
Network Settings
1
Press the [RECEIVER] REMOTE 
MODE button, followed by the 
[SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.
2
Use the Up and Down [
q]/[w] 
buttons to select “7. Hardware 
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
7. Hardware 
Setup
1. Remote 
ID
2. Multi 
Zone
3. Tuner
4. HDMI
5. Network
6. Firmware 
Update
3
Use the Up and Down [
q]/[w] 
buttons to select “5. Network”, 
and then press [ENTER].
The “Network” screen appears.
4
Use the Up and Down [
q]/[w] 
buttons to select the setting, and 
use the Left and Right [
e]/[r] 
buttons to set them.
To enter an IP address, select the set-
ting, and then press [ENTER]. The 
arrow [
q]/[w]/[e]/[r] buttons can 
then be used to enter numbers. Press 
[ENTER] again to set the number.
The settings are explained below.
5
When you’ve finished, press the 
[RETURN] button.
The save confirmation screen appears.
6
Use the Up and Down [
q]/[w] 
buttons to select “Save”, and 
then press [ENTER].
When modifying network settings, 
after modifying it is necessary to exe-
cute “Save”.
7
When you’ve finished, press the 
[SETUP] button.
The setup menu closes.
7-5.  Network
MAC Address
DHCP   
 IP 
Address
 Subnet 
Mask
 Gateway
 DNS 
Server
Proxy URL
Proxy Port
xx : xx : xx − yy : yy : yy
Enable
aaa.bbb.ccc.ddd
aaa.bbb.ccc.ddd
aaa.bbb.ccc.ddd
aaa.bbb.ccc.ddd
8080
Save
Cancel
7-5.  Network
TX-NR807_En.book  Page 113  Tuesday, July 28, 2009  12:00 PM