Marantz SR7002 User Guide

AAC

You can select the display mode for the front display 
of the unit.
To select this mode, press the DISPLAY on the 
remote controller or the front panel.
When this button is pressed, the display mode is 
switched in the following sequence.
Input Mode → Surround Mode → Auto display OFF 
→ Display OFF → Normal Mode → Input Mode

Displays the selected input function. If the function 
has been renamed using the Function Rename 
feature (see page 44), the renamed name appears 
on the display.

Displays the input mode set via the Function Input 
Setup feature (see page 43).

Displays the status of the selected surround 
mode.

The display is off. But, if you make a change to 
the unit such as the input or surround mode, the 
display will show that change, then go back to off 
after about 3 seconds. When changing the volume, 
it is not displayed.

The display is off completely.

• Only the DISP indicator will be illuminated on the 

front display in display off condition.

In normal operation, the audio or video source 
selected for listening through this unit is sent to the 
record outputs.
This means that any program you are watching 
or listening to may be recorded simply by placing 
machines connected to the outputs for TAPE OUT, 
CD/CDR OUT, VCR1 OUT, and DSS/VCR2 OUT in 
the record mode.

 

  Select the input source to record by turning the 

INPUT FUNCTION SELECTOR knob on the 
front panel or simply press the input selector 
buttons on the remote controller.

 

  The input source is now selected and you may 

watch or listen to it as desired.

 

  The currently selected input source signal 

is output to the TAPE OUT, CD/CDR OUT, 
VCR1 OUT, and DSS/VCR2 OUT outputs for 
recording. 

 

  Start recording to the recording component as 

desired.

If you have already assigned the digital inputs, you 
can temporarily select the audio input mode for each 
input source as following procedures.
Press the AMP button and press the > button until 
PAGE4 is displayed. Press the A/D (D3) button. 
When this button is pressed, the input mode is 
switched in the following sequence.
Auto → HDMI → Digital → Analog → Auto

The types of signals being input to the digital and 
analog input jacks for the selected input source are 
detected automatically.
If no digital signal is being input, the analog input 
jacks are selected automatically.

HDMI mode can be selected only when an HDMI 
input has been assigned as an input source.
When “HDMI AUDIO” under PREFERENCE of the 
SETUP MENU is set to “THROUGH”, the HDMI 
mode cannot be selected.

The input signal is fi xed to an assigned digital input 
terminal.

The analog input jacks are selected.

This selection is temporary and will not be stored in 
memory.
To store changes to the input mode, select “1. INPUT 
SETUP” from the MAIN MENU. (See page 43)

This jack may be used to listen to the unit’s output 
through a pair of headphones. Be certain that the 
headphones have a standard 1/4” stereo phono 
plug. 
Note that the speakers will automatically be turned 
off when the headphone jack is in use.

• When using headphones, the surround mode will 

change to STEREO and Dolby Headphone by 
MENU and Cursor button.

• The surround mode returns to the previous setting 

as soon as the headphone plug is removed from the 
jack.

SR7002-8002_U_01_ENG 3_3.indd   64

SR7002-8002_U_01_ENG 3_3.indd   64

07.8.24   1:16:05 PM

07.8.24   1:16:05 PM