Pioneer VSX-522-K User Manual

Page of 39
Additional information
7
7
37
About iPod/iPhone
“Made for iPod” and “Made for iPhone” mean that an 
electronic accessory has been designed to connect 
specifically to iPod or iPhone, respectively, and has been 
certified by the developer to meet Apple performance 
standards. Apple is not responsible for the operation of this 
device or its compliance with safety and regulatory standards. 
Please note that the use of this accessory with iPod or iPhone 
may affect wireless performance.
Apple, iPhone, iPod, iPod shuffle, iPod nano, iPod classic, iPod 
touch and iTunes are trademarks of Apple Inc., registered in the 
U.S. and other countries.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the 
factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down 
BAND
, press and hold 
STANDBY/ON
 for about two seconds.
3
When you see RESET? appear in the display, press 
AUTO SURROUND/STREAM DIRECT
.
OK?
 shows in the display.
4
Press 
ALC/STANDARD SURR
 to confirm.
OK
 appears in the display to indicate that the receiver 
has been reset to the factory default settings.
Important
If the ARC function is ON, you may not be able to initialize 
the unit. If this happens, turn OFF the ARC function or turn 
OFF all the connected device before turning OFF 
(STANDBY) the power for this unit, and initialize after the 
HDMI indicator goes out.
If the Standby Through is not set to OFF, you may not be 
able to initialize the unit.
Cleaning the unit
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the surface is dirty, wipe with a soft cloth dipped in 
some neutral cleanser diluted five or six times with water, 
and wrung out well, and then wipe again with a dry cloth. 
Do not use furniture wax or cleansers.
Never use thinners, benzine, insecticide sprays or other 
chemicals on or near this unit, since these will corrode the 
surface.
Specifications
Amplifier section
Continuous average power output of 80 watts* per 
channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no 
more than 0.08 %** total harmonic distortion.
Front (stereo) . . . . . . . . . . . . . . . . . . . . . . . . . . .80 W + 80 W
Power output (1 kHz, 6 Ω, 1 %). . . . . . . . . . 140 W per channel
Guaranteed speaker impedance  . . . . . . . . . . . . . . 6 Ω to 16 Ω
* Measured pursuant to the Federal Trade Commission’s Trade 
Regulation rule on Power Output Claims for Amplifiers
** Measured by Audio Spectrum Analyzer
Audio Section
Input (Sensitivity/Impedance)
LINE  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 kΩ
Signal-to-Noise Ratio (IHF, short circuited, A network)
LINE  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 98 dB
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
LINE  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79 dB
Video Section
Signal level
Composite . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Vp-p (75 Ω)
Tuner Section
Frequency Range (FM) . . . . . . . . . . . . . . 87.5 MHz to 108 MHz
Antenna Input (FM) . . . . . . . . . . . . . . . . . . . .  75 Ω unbalanced
Frequency Range (AM) . . . . . . . . . . . . . . . 530 kHz to 1700 kHz
Antenna (AM). . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna
Digital In/Out Section
HDMI terminal  . . . . . . . . . . . . . . . . . . . . . . . . . .Type A (19-pin)
HDMI output type . . . . . . . . . . . . . . . . . . . . . . . . . . 5 V, 100 mA
USB (iPod) terminal . . . . USB2.0 Full Speed (Type A) 5 V, 1 A
Miscellaneous
Power Requirements . . . . . . . . . . . . . . . . . . . . AC 120 V, 60 Hz
Power Consumption. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 415 W
In standby . . . . . . . . . . . . . . . . . . . . . . . . . . 0.4 W (ARC OFF)
Dimensions . . . . . .435 mm (W) x 168 mm (H) x 342.5 mm (D)
17
3
/
16
 in. (W) x 6
5
/
8
 in. (H) x 13
1
/
2
 in. (D)
Weight (without package) . . . . . . . . . . . . . . .8.7 kg (19 lb 3 oz)
Furnished Parts
Microphone (for Auto MCACC setup). . . . . . . . . . . . . . . . . . .  1
Remote control   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
Dry cell batteries (AAA size IEC R03) . . . . . . . . . . . . . . . . . . .  2
AM loop antenna  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
Quick start guide  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
Safety Brochure  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
These operating instructions (CD-ROM)
Note
Specifications and the design are subject to possible 
modifications without notice, due to improvements.