Pioneer VSX-520 User Guide
Additional information
09
51
En
English
Français
Español
Important information regarding
the HDMI connection
the HDMI connection
There are cases where you may not be able to
route HDMI signals through this receiver (this
depends on the HDMI equipped component
you are connecting-check with the
manufacturer for HDMI compatibility
information).
route HDMI signals through this receiver (this
depends on the HDMI equipped component
you are connecting-check with the
manufacturer for HDMI compatibility
information).
If you aren’t receiving HDMI signals properly
through this receiver (from your component),
please try the following configuration when
connecting up.
through this receiver (from your component),
please try the following configuration when
connecting up.
Configuration
1
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the BAND button,
press and hold the
STANDBY/ON button
for about two seconds.
3
When you see RESET? appear in the
display, press AUTO SURROUND/STREAM
DIRECT.
OK? shows in the display.
DIRECT.
OK? shows in the display.
4
Press STEREO/ALC to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
receiver has been reset to the factory default
settings.
Note
1
•
If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
•
Depending on the component, audio output may be limited to the number of channels available from the connected display
unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
•
If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit.
•
Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every
time you switch input sources.
VSX-520_UCSMXCN_En.book 51 ページ ２００９年１２月１５日 火曜日 午後２時３３分