Pioneer VSX-919AH-K User Manual
Additional information
12
109
En
Remote control
HDMI
Symptom
Remedy
Cannot be remote controlled. • Set a 5-digit preset code corresponding to the receiver to be operated in the
remote control (see
• Check whether the receiver’s remote control mode is properly set (see
Remote Control Mode Setup on page 101).
Remote Control Mode Setup on page 101).
• Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor
on the front panel (see
on the front panel (see
• Check that there are no obstacles between the receiver and the remote
control.
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
remote sensor.
• Check the connections of the
CONTROL IN jack (see Operating other Pioneer
Other components can’t be
operated with the system
remote.
operated with the system
remote.
• If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
codes.
Symptom
Remedy
The HDMI indicator blinks
continuously.
continuously.
• Check all the points below.
No picture or sound.
• This receiver is HDCP-compatible. Check that the components you are
connecting are also HDCP-compatible. If they are not, please connect them
using the component or composite video jacks.
connecting are also HDCP-compatible. If they are not, please connect them
using the component or composite video jacks.
• Depending on the connected source component, it’s possible that it will not
work with this receiver (even if it is HDCP-compatible). In this case, connect
using the component or composite video jacks between source and receiver.
work with this receiver (even if it is HDCP-compatible). In this case, connect
using the component or composite video jacks between source and receiver.
• If the problem still persists when connecting your HDMI component directly
to your monitor, please consult the component or monitor manual or contact
the manufacturer for support.
to your monitor, please consult the component or monitor manual or contact
the manufacturer for support.
• If video images do not appear on your TV or flat panel TV, try adjusting the
resolution, DeepColor or other setting for your component.
resolution, DeepColor or other setting for your component.
• If
‘NOT SUPPORT’ appears in the receiver’s display, try adjusting the
resolution, DeepColor or other setting for your component.
• While analog video signals are being output over HDMI, use a separate
connection for audio output.
connection for audio output.
• When this receiver reproduces MULTI CH IN audio sources with the HDMI
setting set to THROUGH, you cannot hear audio output from all channels. In
this case, make a digital or analog audio connection.
setting set to THROUGH, you cannot hear audio output from all channels. In
this case, make a digital or analog audio connection.
• To output signals in DeepColor, use an HDMI cable (High Speed HDMI™
Cable) to connect this receiver to a component or TV with the DeepColor
feature.
Cable) to connect this receiver to a component or TV with the DeepColor
feature.
No picture.
• Try changing the Resolution setting (in
VSX-1019_KU.book Page 109 Thursday, January 8, 2009 12:01 PM