Pioneer VSX-919AH-K User Manual
Controlling the rest of your system
09
73
En
Chapter 9:
Controlling the rest of your
system
system
Operating multiple receivers
The remote control included with this receiver
can be used to operate up to three other
receivers (of the same model as this receiver)
in addition to this receiver. The receiver to be
operated is switched by inputting the preset
code to set the remote control setting.
can be used to operate up to three other
receivers (of the same model as this receiver)
in addition to this receiver. The receiver to be
operated is switched by inputting the preset
code to set the remote control setting.
• Set the remote modes on the receivers
before using this function (see
1
Check the operation selector switch to
MAIN.
2
Press .
3
Press and hold REMOTE SETUP, then
release it after the LED flashes twice.
4
Use the number buttons to enter the 5-
digit preset code (see below).
• Receiver 1:
6 1 9 3 5 (Default)
• Receiver 2:
6 2 6 3 0
• Receiver 3:
6 2 6 3 1
• Receiver 4:
6 2 6 3 2
When the preset code is fully input, the LED
flashes once to indicate that the setting is
completed.
flashes once to indicate that the setting is
completed.
To operate another receiver, start over from
step 1 to input its preset code.
step 1 to input its preset code.
Setting the remote to control
other components
other components
Most components can be assigned to one of
the input function buttons (such as
the input function buttons (such as
DVD or
CD) using the component’s manufacturer
preset code stored in the remote.
preset code stored in the remote.
However, there are cases where only certain
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
Note
• You can cancel or exit any of the steps by
pressing
. To go back a step,
press
RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1
Press the input function button for the
component you want to control.
1
When assigning preset codes to
TV CONTROL,
press
TV CTRL here.
2
Press and hold REMOTE SETUP, then
release it after the LED flashes twice.
3
Use the number buttons to enter the 5-
digit preset code.
See
See
RECEIVER
Note
1 You can’t assign
,
TUNER, iPod/USB or SIRIUS.
RECEIVER
RECEIVER
VSX-1019_KU.book Page 73 Thursday, January 8, 2009 12:01 PM