Pioneer 915 User Manual

Page of 76
 
Additional information
13
 
74
 
En
 
FM Tuner Section
 
Frequency Range  . . . . . . . . 87.5 MHz to 108 MHz
Usable Sensitivity . . . . . . . . . .Mono:13.2 dBf, IHF 
(1.3 µV/ 75 
 
Ω
 
)
50 dB Quieting Sensitivity  . . . . . . . Mono: 20.2 dB
Stereo: 38.6 dBf
Signal-to-Noise Ratio . . . Mono: 73 dB (at 85 dBf)
Stereo: 70 dB (at 85 dBf)
Distortion . . . . . . . . . . . . . . .  Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity. . . . . . . . . . . . 60 dB 
(400 kHz)
Stereo Separation . . . . . . . . . . . . . . . 40 dB (1 kHz)
Frequency Response  . . . . . . . . . . 30 Hz to 15 kHz 
(±1 dB)
Antenna Input (DIN) . . . . . . . . .  75 
 
Ω
 
 unbalanced
 
AM Tuner Section
 
Frequency Range  . . . . . . . .  530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna) . . . . . . . 350 µV/m
Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . 50 dB
Antenna . . . . . . . . . . . . . . . . . . . . . .  Loop antenna
 
Miscellaneous
 
Power requirements . . . . . . . . . . . AC 120V / 60Hz
Power consumption . . . . . . . . . . . . 360W / 480 VA
In standby  . . . . . . . . . . . . . . . . . . . . . . . . .  0.5 W
Dimensions . . .16
 
9
 
/
 
16
 
 (W) x 6
 
1
 
/
 
4
 
 (H) x 15
 
7
 
/
 
8
 
 (D) in.
420 (W) x 158 (H) x 402.5 (D) mm
Weight (without package)  . . . . . . 22.4 lb (10.2 kg)
 
Furnished Parts
 
Microphone (for Auto MCACC setup). . . . . . . . . 1
 
Dry cell batteries (AA size IEC R6)
 
. . . . . . . . . . 2
Remote control   . . . . . . . . . . . . . . . . . . . . . . . . . . 1
AM loop antenna  . . . . . . . . . . . . . . . . . . . . . . . . . 1
FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
These operating instructions
 
 Note
 
• Specifications and the design are subject 
to possible modifications without notice, 
due to improvements.
 
Power cord caution
 
Handle the power cord by the plug. Do not pull 
out the plug by tugging the cord and never 
touch the power cord when your hands are wet 
as this could cause a short circuit or an electric 
shock. Do not place the unit, a piece of 
furniture, etc., on the power cord, or pinch the 
cord. Never make a knot in the cord or tie it 
with other cords. The power cords should be 
routed such that they are not likely to be 
stepped on. A damaged power cord can cause 
a fire or give you an electrical shock. Check the 
power cord once in a while. When you find it 
damaged, ask your nearest Pioneer authorized 
service center or your dealer for a replacement.
 
Cleaning the unit
 
• Use a polishing cloth or dry cloth to wipe 
off dust and dirt.
• When the surface is dirty, wipe with a soft 
cloth dipped in some neutral cleanser 
diluted five or six times with water, and 
wrung out well, and then wipe again with a 
dry cloth. Do not use furniture wax or 
cleansers.
• Never use thinners, benzine, insecticide 
sprays or other chemicals on or near this 
unit, since these will corrode the surface.
VSX_815-915.book.fm 74 ページ 2004年12月8日 水曜日 午後4時3分