Sony STR-DN1000 User Manual

• Place the receiver in a location with adequate 

ventilation to prevent heat buildup and 
prolong the life of the receiver.

• Do not place the receiver near heat sources, 

or in a place subject to direct sunlight, 
excessive dust, or mechanical shock.

• Do not place anything on top of the cabinet 

that might block the ventilation holes and 
cause malfunctions.

• Do not place the receiver near equipment 

such as a TV, VCR, or tape deck. (If the 
receiver is being used in combination with a 
TV, VCR, or tape deck, and is placed too 
close to that equipment, noise may result, 
and picture quality may suffer. This is 
especially likely when using an indoor 
antenna (aerial). Therefore, we recommend 
using an outdoor antenna (aerial).)

• Use caution when placing the receiver on 

surfaces that have been specially treated 
(with wax, oil, polish, etc.) as staining or 
discoloration of the surface may result.

Before connecting other components, be sure 
to turn off and unplug the receiver.

Clean the cabinet, panel, and controls with a 
soft cloth slightly moistened with a mild 
detergent solution. Do not use any type of 
abrasive pad, scouring powder, or solvent, 
such as alcohol or benzine.

If you have any questions or problems 
concerning your receiver, please consult your 
nearest Sony dealer.

If you experience any of the following 
difficulties while using the receiver, use this 
troubleshooting guide to help you remedy the 
problem. Should any problem persist, consult 
your nearest Sony dealer.

• Check that the speakers and components 

are connected securely.

• Check that all speaker cords are connected 

correctly.

• Check that both the receiver and all 

components are turned on.

• Check that MASTER VOLUME control is 

not set to “VOL MIN”.

• Check that the SPEAKERS is not set to off 

• Check that headphones are not connected.
• Press MUTING to cancel the muting 

function.

• Check that you have selected the correct 

component with the input buttons (page 
47).

• When only a very low-level sound is 

heard, check to see if NIGHT MODE 
function is activated (page 112).

• The protective device on the receiver has 

been activated. Turn off the receiver, 
eliminate the short-circuit problem, and 
turn on the power again.