Sony DH840 User Manual

D:\NORM'S JOB\SONY HA\SO0190\STR-DH730_DH830_PMRF 
01\4408151112_GB\GB05ENJ_STR-DH730-CEL.fm

STR-DH830/STR-DH730

4-408-151-11(2)

 

 

 

 

 

 

 

You can make the required settings for 
equipment connected to the HDMI jack.

x Ctrl for HDMI (Control for HDMI)

Lets you turn the Control for HDMI function 
on or off. For details, see “Preparing for the 
“BRAVIA” Sync” (page 56).
• ON
• OFF

When you set “Ctrl for HDMI” to “ON”, “Audio 
Out” may be changed automatically.

x Pass Through

Lets you output the HDMI signals to the TV 
even when the receiver is in standby mode.
• ON: When the receiver is in the standby 

mode, the receiver continuously outputs 
HDMI signals from the receiver’s HDMI 
TV OUT jack.

• AUTO: When the TV is turned on while the 

receiver is in the standby mode, the receiver 
outputs HDMI signals from the receiver’s 
HDMI TV OUT jack. Sony recommends 
this setting if you use a “BRAVIA” Sync 
compatible Sony TV. This setting saves 
power in the standby mode when compared 
with the “ON” setting.

• OFF: The receiver does not output HDMI 

signals when the receiver is in the standby 
mode. Turn on the receiver to enjoy the 
connected equipment’s source on the TV. 
This setting saves power in the standby 
mode when compared with the “ON” 
setting.

• This function is not available when “Ctrl for 

HDMI” is set to “OFF”.

• When “AUTO” is selected, it may take a little more 

time for the image and sound to be output to the TV 
than when “ON” is selected.

• When the receiver is in standby mode, 

 

“A.STANDBY” appears on the display panel if 
“Pass Through” is set to “AUTO” or “ON”. 
However, “A.STANDBY” will disappear when 
“Pass Through” is set to “AUTO” and no signals 
are detected.

x Audio Out

Lets you set the HDMI audio signals output 
from the playback equipment connected to the 
receiver via an HDMI connection.
• AMP: The HDMI audio signals from the 

playback equipment is only output to the 
speakers connected to the receiver. Multi 
channel sound can be played back as it is.

• TV+AMP: The sound is output from TV’s 

speaker and the speakers connected to the 
receiver.

• The sound quality of the playback equipment 

depends on the TV’s sound quality, such as the 
number of channels, and the sampling 
frequency, etc. If the TV has stereo speakers, the 
sound output from the receiver is also in stereo as 
that of the TV, even if you play back multi 
channel source.

• When you connect the receiver to an image 

display equipment (projector, etc.), sound may 
not be output from the receiver. In this case, 
select “AMP”.

You can customize the settings of the receiver.

x Auto Standby

Lets you set the receiver switch to standby 
mode automatically when you do not operate 
the receiver or when there is no signals input to 
the receiver.
• ON: Switches to standby mode after 

approximately 30 minutes.

• OFF: Does not switch to standby mode.