Sony 3-289-204-41(1) User Manual

C:\NORMAN\SONY HA\STR-DA2400ES\3289204411\04GB-STRDA2400ESUC\070SET_GB.fm

STR-DA2400ES
3-289-204-41(1)

x Test Tone

• OFF
• AUTO

The test tone is output from each speaker in 
sequence.

• FL, CNT, FR, SR, SBR, SBL, SB, SL, SW

You can select which speakers will output 
the test tone.

x Phase Noise

• OFF
• FL/FR, FL/CNT, CNT/FR, FR/SL, FR/SR, 

SR/SL, SR/SBR, SBR/SBL, SR/SB,  SBL/
SL, SB/SL, SL/FL, FL/SR
Lets you output the test tone sequentially 
from adjacent speakers.
Some items may not be displayed, 
depending on the setting of the speaker 
pattern.

x Phase Audio

• OFF
• FL/FR, FL/CNT, CNT/FR, FR/SL, FR/SR, 

SR/SL, SR/SBR, SBR/SBL, SR/SB,  SBL/
SL, SB/SL, SL/FL, FL/SR
Lets you output front 2 channel source sound 
(instead of the test tone) sequentially from 
adjacent speakers.
Some items may not be displayed, 
depending on the setting of the speaker 
pattern.

x BI-AMP Speaker

• ON

If you connect front speakers in a bi-
amplifier configuration, select “ON”.

• OFF

If you have not connected surround back 
speakers, select “OFF”.

Set “BI-AMP Speaker” to “OFF”, then connect the 
surround back speakers to this receiver when you 
want to change the connection from a bi-amplifier 
connection to a surround back speakers connection. 
Re-set up the speakers after you connect the 
surround back speakers. Refer to “Auto Calibration” 
(page 44) or “Manual Setup” (page 66).

x Crossover Freq

Lets you set the bass crossover frequency of 
speakers that has been set to “SMALL” in the 
Speaker menu. Measured speaker crossover 
frequency is set for each speaker after the Auto 
Calibration.
The adjusted value is set for each speaker 
when you adjust the speaker crossover 
frequency using “Crossover Freq” after the 
Auto Calibration.