Simaudio Preamplifier and D/A converter User Manual

 

 

MOON Stargate Processor 

 

Full Function Remote Control Programming 

 

This remote control allows you to transfer a command from a button on your source remote control 

(original equipment remote control) to a button on the Stargate remote control.  New commands can 
be taught to any button in the CD, DVD, AUX, SAT, TV, VCR and CBL device modes, except on the 

 button. 

 
The remote control provides distinct visual feedback with LEDs (Light Emitting Diodes) that are located 

at the top left of the remote control (Status LED) and under the Device buttons. The Status LED at the 
top left of the remote operates in three colors (red, orange and green). The Device buttons have a red 
color LED behind them. These LEDs will assist you in programming in the learning section of the 

remote control. 

 

 

Select a Device mode in which you would like to teach the new command.  For example, if you wanted 
to learn a new command to the 

 button in the TV mode on the remote, you would select the 

 Device button and use the instructions below to teach the new command to the 

 button. 

 
Step 1:   

Press the Device button and the SELECT button simultaneously and hold until the orange Status 
LED and the Device button turn on and remain lit. 

 

Step 2:   

On the remote control, press the button that is to be taught the new command. The orange 
Status LED will begin to flash continuously. The Device LED will turn off. 

 

Step 3:   

On the source remote control (original remote control), press and hold the button for the 

command to be learned until the Status LED on the remote turns green. Release the button on 
the source remote control. 

 

Step 4:   

Press the button on the source remote control, once again to verify that the new command has 
been learned correctly. The Status LED will flash green twice and then turn to a steady orange 

color indicating that the programming was successful. The Device LED will turn on. 

 

Repeat   

Steps 2 through 4 for any other buttons to be taught in the Device mode selected in 

Step 1. 

 

Step 5:   

Once you have completed learning new commands to the buttons in the selected Device mode 
you must save the programmed information. Press and hold the Device button and SELECT 

button simultaneously and hold until the orange Status LED flashes twice. The Device button will 
turn off. 

 

Repeat the above for any other Device modes 

____________________________________________________________________________________ 

 

Full Function Remote Control Programming 

 

 

 

                     15