Radio Shack 04A00 User Manual

5

Connections

The following drawings show recommended
speaker placements for typical, narrow, and
wide sound coverage.

ˆ

You can connect a component such as an
audio mixer or preamplifier to the inputs on
the back of your amplifier. Each input (la-
beled 

 and 

) has a bal-

anced and unbalanced jack. You need a
shielded cable with a 

1

/

4

-inch (6.35-mm)

phono plug to connect to an unbalanced jack
or a cable with a phono-type plug to connect
to a balanced jack. To prevent hum and oth-
er noise, use low-capacitance shielded ca-
ble. Your local RadioShack store carries a
wide selection of audio components, parts,
and cables.

Note:  If you are using the 

 level inputs,

you must connect an audio mixer or pre-am-
plifier to this amplifier.

 

• You can connect audio mixers or pream-

plifiers to either the balanced or unbal-
anced jacks. Do not connect input
sources to both jacks at the same time.

• Before you make any connections, be

sure 

 on the front of the amplifier

is off and the AC power cord is not
plugged in.

If you are connecting more than one speaker
on the same channel (unbridged connec-
tion), connect your audio mixer’s or preampli-
fier’s left and right output jacks to the 

and 

jacks on the back of the ampli-

fier. Then, make sure 

 on the

back of the amplifier is set to 

.

If you are connecting high-power speakers
that can handle a power output of 350 watts
(bridged connection), connect your audio
mixer’s or preamplifier’s output jack to the 

or 

jack on the back of the