Linn 500 Solo User Manual

20.

Servicing. Don’t attempt to service the product beyond that described in the operating instructions. All

other servicing should be referred to qualified service personnel.

This appliance is fitted with a non-rewireable 13 Amp mains plug. The plug contains a 5 Amp fuse. If the fuse
has blown it can be replaced as follows:

a) Pull out the red fuse cover/carrier.

b) Remove and dispose of the blown fuse.

c) Fit a new 5 Amp BS1362 approved fuse into the carrier and push the carrier back into the plug.

Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the plug. Contact your Linn retailer
to obtain a replacement fuse cover.

Fuses are for fire protection and do not protect against electric shock.

Should your mains plug need replacing and you are competent to do this, proceed as follows. If you are in
doubt, contact your Linn retailer or a competent electrician.

a)

Disconnect the plug from the mains supply.

b) Cut off the plug and dispose of it safely. A plug with bared conductors is dangerous if engaged in

a live socket.

c)

Only fit a 13 Amp BS1363A approved plug with a 5 Amp fuse.

d)

The cable wire colours or a letter will be marked at the connection points of most quality plugs.

Attach the wires securely to their respective points. The Brown wire must go to the Live pin, the Blue

wire must go to the Neutral pin and the Green/Yellow wire must go to the Earth pin.

e)

Before replacing the plug top, ensure that the cable restraint is holding the outer sheath of the

cable firmly and that the wires are correctly connected.

THIS APPLIANCE MUST BE EARTHED.

Should the mains fuse blow, replace it only with an equivalent part. The fuse holder is located just below the
mains inlet socket. To replace the fuse, disconnect the product from the mains supply. Using a flat blade
screwdriver remove and replace the fuse. If the fuse blows a second time there is a fault in the product. Contact
your local retailer.

Fuse ratings. See specifications section.
Mains voltage operating range. See specifications section.