Mark Levinson 500H User Manual
7
Nº500H Series Power Amplifier
Rear Panel
The images below show a one-channel, two-channel, three-channel
and five-channel rear panel view.
and five-channel rear panel view.
Power Switch
Controls the AC power to the input of the amplifier when a
power cord is connected from the electrical outlet to the AC input
connector on the rear panel.
power cord is connected from the electrical outlet to the AC input
connector on the rear panel.
When the Power switch is pressed to turn on the unit, the amplifier
enters the Standby mode.
enters the Standby mode.
The audio outputs of this power amplifier are considered Class 2 (CL2)
circuits in North America. This means the wire connected between this
amplifier and the speaker(s) shall be rated at minimum Class 2 (CL2)
and shall be installed according to the U.S. National Electrical Code
(NEC) Article 725 or Canadian Electrical Code (CEC) Section 16.
circuits in North America. This means the wire connected between this
amplifier and the speaker(s) shall be rated at minimum Class 2 (CL2)
and shall be installed according to the U.S. National Electrical Code
(NEC) Article 725 or Canadian Electrical Code (CEC) Section 16.
Note
Loudspeaker
Binding Posts
Audio Input
AC Input
Power Switch
Ethernet Port
Trigger Input/Output
Trigger Input/Output
Loudspeaker
Binding Posts
Audio Input
AC Input
Power Switch
Ethernet Port
Trigger Input/Output
Trigger Input/Output
Loudspeaker
Binding Posts
Audio Input
AC Input
Power Switch
Ethernet Port
Trigger Input/Output
Trigger Input/Output
Loudspeaker
Binding Posts
Audio Input
AC Input
Power Switch
Trigger Input/Output
Ethernet Port
Nº531H Monaural
Power Amplifier (1 x 300W)
Nº532H Dual-Channel
Power Amplifier (2 x 300W)
Nº533H Three-Channel
Power Amplifier (3 x 300W)
Nº535H Five-Channel
Power Amplifier (5 x 200W)