Mark Levinson 500H User Manual

19

Nº500H Series Power Amplifier

The figure below illustrates a typical ML Net setup:

Before the master device can control any slave device, the slave 
devices must be “discovered” and assigned to the master device.
Refer to the Owner’s Manual of the designated master device for
further information about discovering and assigning slave devices.

 
The Nº500H series slave(s) can report the following status 
information to the master device:

•  

Temperature – the current operating temperature of the 
amplifier(s).

•  

Session Time – the amount of time that the amplifier(s)  
has been powered on.

•

 Total On Time – the total amount of hours that the 
amplifier(s) has been powered on since its manufacture.

If a slave device is inactive, unassigned, or assigned to a different 
master, then status information is not available.

The Nº500H series slave(s) also reports fault information to the 
master device. If a slave device is inactive, unassigned, or assigned 
to a different master, then error reporting is not available. For more
information about possible fault conditions, refer to the 
“Troubleshooting” section of the manual.