Denon AVC-A1HD User Manual

Optimize settings for speakers in use.

F Menu tree F

a

s

d

a

The settings are performed automatically.

GAuto Setup flowH

STEP1  Preparation 

vpage 14, 15

STEP2  Detection & Measurement (main)

vpage 16, 17

STEP3  Measurement (2nd – 8th) 

vpage 18

STEP4  Calculation 

vpage 18

STEP5  Check 

vpage 19

STEP6  Store 

vpage 19

vpage 20

• Configure the following settings as required.
• To  start  Auto  Setup  without  configuring  the  following  settings,

perform step 4 only, and then proceed to step 2.

n  Amp Assign   

Select the method for using the power amplifier in accordance with
the connected speaker configuration.
Choose this when “Amp Assign” in the GUI menu is set to anything
other than “Normal”.

n  Pre-out Assign   

Change the pre-out terminal assignment.

n  XLR Out Polarity   

Set to switch the XLR pre-out terminal polarity.

n  Channel Select   

The measurement time can be shortened by selecting the speakers
to be measured in advance. Please set if necessary.
When  measuring  2  or  3  subwoofers,  configure  the  “Channel
Select” settings.

• “Front Height” is displayed when the “Amp Assign” – “Assign Mode”

setting (

vpage 28) in the GUI menu and the “Extension Channel”

setting (

vpage 28, 29) are set to “Front Height”.

• “Front Wide” is displayed when the “Amp Assign” – “Assign Mode”

setting (

vpage 28) in the GUI menu and the “Extension Channel”

setting (

vpage 28, 29) are set to “Front Wide”.