Maxxsonics GPV3500.2 User Manual
6
Basic application
Crossover frequency control checklist:
These sub bass amplifiers can be used in any of the bi-amplification systems described in
LOW PASS: 40Hz to 150Hz
this manual, replacing the 2 channel amplifiers as per the illustrations.
SUBSONIC:15 Hz to 55 Hz
BASS EQ: 0 to +9dB
BASS EQ: 0 to +9dB
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.
Connect the LINE OUT to the inputs of the system highs amplifier.
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.
Connect the LINE OUT to the inputs of the system highs amplifier.
Level control checklist:
Refer to the section “Setting up systems after installation for best performance”
Refer to the section “Setting up systems after installation for best performance”
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers
simplifying the hookup of multiple speakers
Minimum final loudspeaker impedance: 1-Ohm.
FULL RANGE
STEREO LINE INPUT
NOT USED
Y-ADAPTOR
Note: You can use the Radio/CD designated mono line output or a full range stereo line output.
For full range stereo line output, you will need an optional “Y-Adaptor” as shown.
For full range stereo line output, you will need an optional “Y-Adaptor” as shown.
GPV2100.1 A/B CLASS 1 CHANNEL AMPLIFIER APPLICATION
PARALLEL MONO
SUBWOOFERS
2-OHMS EACH MINIMUM
MONO
SUBWOOFER
POWER
SPEAKER
FUSE
GND REM +12V
-
-
+
+
POWER
SPEAKER
FUSE
GND REM +12V
-
-
+
+
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY + 12 Volts VIA FUSE
DESIGNATED
MONO OUTPUT
FROM HEAD UNIT
MIN
MAXX
GPR-1
BA
SS
SS
BASS BOOST SUBSONIC LOWP
ASS LEVEL
0dB 9dB 15Hz 55Hz 40Hz 150Hz 6V 0.2V
LINE OUT
LINE INPUT
POWER
PROTECT
REMOTE
CONTROL
L
L
R
R
GROUND POUNDER
DRIVE