Xantech MRAUDIO8X8 User Manual

 

 

08905142A 

15

SPEAKERS 
Head End Connections 
Use the included 4-conductor plug-in connectors, (6 included) to connect speaker 
wires to the MRC88. 
1.  Strip each speaker wire conductor’s insulation back about ¼ inch (6mm) and 

twist the ends to prevent fraying. 

2.  Insert the leads into the appropriate “L+, L-”/“R+, R-” Terminals on each 

plug-in connector. Confirm polarity. Slightly pull the connected wire to 
confirm connection. 

3.  Be sure there are no loose strands that can cause shorts. 
4.  Plug the connector into the appropriate Zone Speaker Terminal. 
5.  Repeat for all zones. 
 
Zone Connections 
Prior to connecting speakers, be sure ceiling/wall openings have been properly 
prepared and that any required mounting hardware is in place. 
1.  Strip each speaker wire conductor’s insulation back about ¼ inch (6mm) and 

twist the ends to prevent fraying. 

2.  Connect the leads to the appropriate “L+, L-”/“R+, R-” Terminals on each 

speaker. Confirm polarity. Slightly pull the connected wire to confirm 
connection. 

3.  Be sure there are no loose strands that can cause shorts. 
4.  Install speakers per manufacturer’s instructions. 
5.  Repeat for all speakers in all zones.