Yamaha YSP-4300 User Manual

Yamaha’s proprietary yAired technology enables the wireless 
connection of the center unit and subwoofer. Wireless connection 
of the subwoofer allows for subwoofer installation without 
concern for cables. When the transmitter (YIT-W12TX) is used, 
iPods or computers can be connected wirelessly to play music 
stored on these devices through this unit.
For details of YIT-W12TX, refer to “Safety and Accessory 
Information” (separate booklet).

When playing content from a TV or Blu-ray disc player, the 
center unit transmits audio signals that are received by the 
subwoofer. When YIT-W12TX is used to play songs stored on an 
iPod or computer, YIT-W12TX sends audio signals that are 
received by the center unit and subwoofer.

The same group ID must be assigned to all components. By 
default, the center unit, subwoofer, and YIT-W12TX are assigned 
a group ID of A1. This group ID does not need to be changed.

The center unit, subwoofer, and YIT-W12TX can be assigned a 
group ID from three possible sets: A1–A3, B1–B3, C1–C3.
A1–A3, B1–B3: Audio delay is less than that of the C1–C3 set. 
C1–C3: Use when playing music stored on a computer via this 
unit (

☞p. 48).

To prevent wireless connection of another yAired Yamaha sound 
system or device installed near this unit or the YIT-W12TX, 
assign a different group ID to this unit and the YIT-W12TX.

Center unit
Change the group ID from “GROUP ID” in the setup menu 
(

☞p. 64).

Subwoofer
Use the group ID switches on the back of the subwoofer to 
change the group ID (

☞p. 20).

YIT-W12TX
Use the group ID switches on the side of YIT-W12TX to change 
the group ID. For details of YIT-W12TX, refer to “Safety and 
Accessory Information” (separate booklet).

Visual operation of this unit 
is possible by displaying its 
menu screen on the TV.
Use the button for switching 
between input sources on the 
TV’s remote control to 
select this unit. 
When this unit and the TV 
are connected as shown 
below, select “HDMI 1”. 

The menu display
The setup menu is displayed on the TV screen when the SETUP 
key is pressed. When the TV is receiving HDMI signals, the 
menu is superimposed over video content. Press the SETUP key a 
second time to cancel setup menu display.

SETUP MENU

BEAM

SOUND
HDMI
yAired
DISPLAY
INFORMATION

IntelliBeam

HORIZONTAL ANGLE
BEAM TRAVEL LENGTH
FOCAL LENGTH
IMAGE LOCATION
CHANNEL OUT

The setup menu (

☞p. 58) can only be displayed on a TV screen. It 

cannot be shown in the front panel display.