Phoenix Gold TI6CS User Manual

© 2010 Phoenix Gold • www.phoenixgold.com  

When installing your Ti Component system you may want to adjust 
your tweeter setting to fit your specific application. Phoenix Gold has 
provided a tweeter adjustment switch in the Ti Component System 
crossover.To access this switch you must first remove the crossover 
cover by squeezing the tabs on the side of the unit (Figure 4) and gently 
twisting the lid counter clockwise. Once the lid is removed you will see 
a switch located in the center of the circuit board. To increase the tweeter 
output move the switch to the +2dB position. If this switch is in the +2dB 
location and you want to decrease the tweeter output move the switch 
to the 0dB position. Once you have your crossover configured place the 
lid back into place by centering the lid over the circuit board and press 
straight down until it snaps into place. 

You will have to do this for each of the two crossovers included with this 
Ti Component System. The process is the same for each.

 

With a variety of supplied mounting options, the Ti series tweeter is easy to install 
in any vehicle. Each Ti component set comes with a flush mount  and surface 
mount installation kit. For other custom mounting configurations, please contact 
your authorized Phoenix Gold Dealer.

Flush Mount:       For optimal tweeter installation, use the Flush Mount option. 

The Flush mount requires 3⁄4” depth and a 2-1/16” hole in the 
mounting surface (figure 5)

Surface Mount:  Screws are provided for use when cutting a hole in the door 

panel or other mounting surface is not an option. Make sure that 
the surface mount location is free of passenger movement that 
might damage the tweeter. (figure 6)

The Ti tweeters pivot in their housings. This allows the user to align the tweeter 
during the installation process for optimum listening results. 

For best results, always try to maintain equal path lengths between the right 
and the left tweeter and the listening position. This is usually accomplished by  
mounting as low and deep as possible in a kick panel installation, or high and 
deep in a dashboard installation. Be cautious in dashboard installations not to  
reflect the tweeter off of the windshield: this increases reflections and can greatly 
diminish the overall system listening quality.

For door panel installations, try to angle the tweeters toward the listener to 
optimize high frequency performance.

Slide the retainer ring over the tweeter 
housing onto the inner cup. Rotate the 
retainer ring to  lock all three pieces into 
place.

Slide the retainer ring over the tweeter 
housing onto the outer cup. Rotate the 
retainer ring to lock all three pieces 
into place.

Once you have the inner portion assembled 
slide it into the outer cup and twist to lock 
into place. 

The spring retainer is what holds the  
tweeter in place. Its fingers clamp  against 
the inside of the wall you are mounting the 
tweeter to.