JBL 260 User Manual

1.  Select the ‘Panel’ number (this must match 

the Dip Switch setting (ID#) set on the ZC 
wall panel). 

2.  Select a ZC-1 (or ZC-2 if using a ZC-2) as 

the ‘Type’. 

3.  Set the maximum amount of ‘Boost’ that will 

be applied (0 dB typical). 

4.  Set the maximum amount of ‘Cut’ that will 

be applied (40 dB typical). 

5.  Select which ‘Output(s)’ you would like this 

ZC to control.

1.  Select the ‘Panel’ number (this must match 

the Dip Switch setting (ID#) set on the ZC 
wall panel). 

2.  Select a ZC-3 as the ‘Type’. 

3.  Select which ‘Program’ will be loaded when 

selecting each corresponding position (A-D) 
on the ZC wall panel.

1.  Select the ‘Panel’ number (this must match 

the Dip Switch setting (ID#) set on the 
ZC-4). 

2.  Select a ZC-4 as the ‘Type’. 

3.  Select which ‘Switch Combination’ (binary #) 

you would like to program. 

4.  After the correct Switch Combination 

number is selected, select which 
‘Program’ will be loaded when this Switch 
Combination is triggered from the custom 
switches, which are connected to the ZC-4. 

Repeat steps 3 and 4 for all remaining Switch Combinations.