Telex DOC02-DN9848 User Manual

Input Channels 

 

 

10 

 

Gain and delay are also set in the first page of the 

channel’s menu, providing easy access for quick 

adjustment during set up or performance. Note that 
the delay can be specified in terms of time or 

distance, as preferred.  The unit of measurement is 

changed in the Set Up menu (see Section 7.6).  

 

  Turn the centre knob slowly for step increments, or sharply to leap to the bottom/top of the 

range (2 or 3 sharp turns will cover the whole range). The range is 0 to 1ms in steps of  

20.83  s and 1ms to 1s in steps of 0.02ms, or the equivalent in metres or feet. 

 

  Turn the right-hand knob.  The range is –40dB to +12dB in steps of 0.1dB, with an OFF 

position just ‘below’ –40dB.  Setting the gain to OFF will mute the input signal. 

The DN9848 provides 12 parametric equalisation stages 

on each input channel, for equalising the input signal in 
respect of room/venue characteristics.  Each stage can 

be used across the full range from 20Hz to 20kHz and is 

set independently via its own menu page. 

 

Set a centre frequency (21 steps per octave) and bandwidth (0.08 to 3 Oct) for the PEQ 

section, using the left and centre knobs, respectively.  

Turn the right-hand knob to set an attention/boost level in the range -18dB to +6dB.  

PEQ sections which are not needed in the set up should be set to 0dB attention/boost. 

Delays can be set in 

seconds, metres, or feet.