Telex DOC02-DN9848 User Manual

Output Channels 

 

 

13 

 

Signal processing for each output channel is programmed independently via the separate Output 

menu associated with each channel.  The signal processing parameters are described below in menu 
order. 

 

  Press its yellow 

MENU ACCESS button (1 – 8) to switch to its menu.  

  Press the button repeatedly to step through the pages in turn.  Note that, after the last page, 

the next button press will cycle the menu back to the first page.  

 

Each output channel can be allocated a name up to 

8 characters long, which will be shown in the first 

page of the menu for easy reference.  The default 

names are Output 1, Output 2, etc.  Names are 
retained after power down and are included in 

stored settings. 

 

Turn the left-hand knob clockwise to access 

the Output Name menu page. 

Use the centre knob to move the cursor right or left, and the right-hand knob to select the 

letter, number or symbol.   

On completion, turn the left-hand knob anti-clockwise to go back to the main page. The new 

name is now shown to the left of the menu page.  

Each output of the DN9848 can be acquired from a single input, a pair of outputs or all outputs.  For 

paired outputs, the source inputs are attenuated by 6dB prior to summing and the ratio of the two 

signals used is adjustable.  When all outputs are 
combined, the source inputs are attenuated by 12dB 

prior to summing in equal proportion.  (See Section 6.1 

for Technical Overview). 

For easy access and reference purposes, the routing is 

selected in the first menu page as shown opposite. 

 

Turn the centre knob to select the required 

source from the following sequence of choices:  

A, B, C, D, A+B, C+D, All. 

If you select A+B or C+D, use the right-hand knob to set the ratio for the signals, i.e. A:B or 

C:D, respectively. 

Important! Delays for the summed channels must be set to the same value. 

The ratio of paired 

outputs is adjustable.  

User defined  

channel name