Yamaha RX-V659 User Manual
117
TROUBLESHOOTING
ADDITIONA
L
INF
O
RMA
T
IO
N
N
After AUTO SETUP
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If warning “W-1” appears, corrections are made, but they may not be optimal.
• If warning “W-2” or “W-3” appears, no corrections are made.
• If error “E-10” occurs repeatedly, please contact a qualified YAMAHA service center.
• If warning “W-1” appears, corrections are made, but they may not be optimal.
• If warning “W-2” or “W-3” appears, no corrections are made.
• If error “E-10” occurs repeatedly, please contact a qualified YAMAHA service center.
Warning message
Cause
Remedy
See
page
W-1:OUT OF PHASE
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or –).
polarity (+ or –).
W-2:OVER 24m (80ft)
The distance between the speaker and the
listening position is over 24 m (80 ft).
listening position is over 24 m (80 ft).
Bring the speaker closer to the listening
position.
position.
—
W-3:LEVEL ERROR
The difference of volume level among
speakers is excessive. (No level correction
is made.)
speakers is excessive. (No level correction
is made.)
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
speakers are set in locations with similar
conditions.
—
Check the speaker connections.
Use speakers of similar quality.
—
Adjust the output volume of the subwoofer.
Notes