Marantz 541110307024M User Manual

ENGLISH

MP3 and WMA fi les that have been recorded onto 
CD-R or CD-RW discs can be played back on this CD 
player. (See page 14)

Direct Disc Access button is equipped both on the 
front panel of the unit and on the remote controller 
for one-touch disc change to any of the 5 discs in 
the unit.

RS-232C port which supports both unit control 
and operating status transmission is equipped to 
enable central control with custom installation. Also, 
Flasher input is equipped to realize wired control 
when you cannot use remote control due to the 
installation on the rack, etc.

Because there are 5 sets of built-in remote control 
code signals for between the unit and remote 
controller, up to 5 units installed in the same place 
can be remotely controlled independently.

Hairline finish aluminum front panel is used for 
quality look.

Your Marantz product complies with the household 
power and safety requirements in your area.  
This product can be powered by 120 V AC only.

To keep your unit in perfect working order for the 
longest possible time, avoid installing the unit in the 
following locations.

•  Wherever it will be exposed to direct sunlight

•  Wherever it will be close to a heater or other heat-

radiating appliance

•  Wherever the humidity is high or ventilation is 

poor

•  Wherever it is very dusty

•  Wherever it will be subject to vibration

•  On top of a rickety stand or in an unstable location 

which is tilted at an angle

•  Near windows where there is a chance of 

exposure to rain, etc.

•  On top of an amplifi er or other component which 

dissipates a great deal of heat

To ensure proper heat dissipation, install the unit 
while leaving clearances between the unit and 
wall or other components, as shown in the fi gure 
below.

Left 0.1 m (4 in) 
or more

Right 0.1 m 

(4 in) or more

Above 0.1 m 
(4 in) or more

Rear 0.1 m (4 in) or more

Refrain from placing any objects on top of the unit.

At the bottom of the player there are two red 
shipping screws for use when the player is 
transported. Before using the player, turn these 
screws counterclockwise and remove them.
If the shipping screws are still in place and the 
power is turned on, unplug the power cord from the 
power outlet and remove the shipping screws.
Retain these screws as they will be needed when 
the player is transported.
Before transporting the player, take out the discs, 
close the disc tray, set to standby mode and unplug 
the power cord from the power outlet. Then install 
the shipping screws by turning them clockwise.  Be 
sure to fasten them securely.

shipping screws

•  In winter, droplets of water form on the insides 

of the windows of a heated room: this is called 
condensation.  This unit uses an optical lens, 
so the condensation may form in the following 
cases.

-  In a room immediately after the heating has 

been turned on

-  In a room where the humidity level is high

-  When the unit has been suddenly brought from 

a cold location into a warm room

  Since, in cases like this, the track numbers 

may not be read and the unit is prevented from 
operating properly, wait about 30 minutes, and 
then operate the unit.

•  If this unit is placed on an object that generates 

substantial heat, such as an amplifi er, the laser 
inside this unit may be deteriorated. 

•  This unit may cause interference on a tuner or TV 

set. If this is the case, place it further away from 
the tuner or TV set.

•  Compact discs have much less noise than analog 

records and hardly any noise is heard before play 
starts. 

  Bear in mind, therefore, that if the volume control 

on the amplifier is set too high, you will risk 
damaging other audio components.

•  This unit cannot play CD-ROMs used with 

personal computers, game CDs, video CDs, 
DVDs (video/audio) or DTS-CDs. 

•  We do not recommend the use of lens cleaners.

•  If this unit is placed in a rack with glass doors, 

do not attempt to open the disc tray with the 

0 

OPEN/CLOSE button on the remote controller 
with the glass doors shut. Impeded disc-tray 
movement may result in a failure. 

CC4003_U_01_Eng.indd   2

CC4003_U_01_Eng.indd   2

09.8.24   4:08:48 PM

09.8.24   4:08:48 PM