Sony RDHGTK1I Manual

model name [FST-GTK2i]

[4-186-872-11(2)] GB

filename[D:\NORM'S JOB\SONY HA\SO0098\G-
Tank_PMRF\4186872112_GB\GB07ADD.fm]

masterpage:Right

• Completely disconnect the power cord (mains 

lead) from the wall socket (mains) if it is not 
going to be used for an extended period of 
time. When unplugging the unit, always grip 
the plug. Never pull the cord itself.

• Should any solid object or liquid get into the 

system, unplug the system, and have it 
checked by qualified personnel before 
operating it again.

• (For customers in United States and Canada 

only)
One blade of the plug is wider than other for 
the purpose of safety and will fit to the wall 
outlet only one way. If you are unable to insert 
the plug fully into the outlet, contact your 
dealer.

• The AC power cord can be changed only by a 

qualified service facility.

• Do not place the system in an inclined 

position or in locations that are extremely hot, 
cold, dusty, dirty, or humid or lacking 
adequate ventilation, or subject to vibration, 
direct sunlight or a bright light.

• Be careful when placing the unit or subwoofer 

on surfaces that have been specially treated 
(for example, with wax, oil, polish) as staining 
or discoloration of the surface may result.

• Heat buildup on the unit during operation is 

normal and is not a cause for alarm.

• Do not touch the cabinet if it has been used 

continuously at a high volume because the 
cabinet may have become hot.

• Do not obstruct the ventilation holes.

This speaker system is not magnetically 
shielded, and the picture on nearby TV sets may 
become magnetically distorted. In this situation, 
turn off the TV, wait 15 to 30 minutes, and turn 
it back on. If there is no improvement, move the 
speakers far away from the TV.

Clean this system with a soft cloth slightly 
moistened with a mild detergent solution. 
Do not use any type of abrasive pad, scouring 
powder, or solvent, such as thinner, benzine, 
or alcohol.

POWER OUTPUT AND TOTAL 
HARMONIC DISTORTION:

RDH-GTK1i USA model only
With 6-ohm loads, both channels driven, 
from 120 Hz – 10 kHz; rated 30 watts per 
channel minimum RMS power, with no 
more than 0.7% total harmonic distortion 
from 250 miliwatts to rated output.

The following are measured at

AC 127 V, 60 Hz

Front speaker:
Power Output (rated)

35 W + 35 W (at 6 

:, 1 kHz, 1% THD)

RMS output power (reference)

110 W + 110 W (per channel at 6 

:, 

1 kHz)

Subwoofer:
RMS output power (reference)

230 W (8 

:, 100 Hz)

North American model only
The following are measured at

AC 120 V, 60 Hz

Front speaker:
RMS output power (reference)

110 W + 110 W (per channel at 6 

:, 

1 kHz)

l