Sony MHC-GX30 Manual

GB

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player.  Should this occur, the system will not
operate properly.  Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.

• When you move the system, take out any discs.

If you have any questions or problems concerning
your stereo system, please consult your nearest Sony
dealer.

• Before playing, clean the CD with a cleaning cloth.

Wipe the CD from the center out.

• Do not use solvents.
• Do not expose the CD to direct sunlight or heat

sources.

Discs recorded on CD-R/CD-RW drives may not be
played back because of scratches, dirt, recording
condition or the drive’s characteristics. Besides, the
discs, which are not yet finalized at the end of
recording, cannot be played back.

Use a soft cloth slightly moistened with mild
detergent solution.

To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated. If you later want to reuse the tape for
recording, cover the broken tab with adhesive tape.

Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.

• Unplug the system from the wall outlet (mains) if it

is not to be used for an extended period of time.  To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

component, unplug the system and have it checked
by qualified personnel before operating it any
further.

• The AC power cord must be changed only at a

qualified service shop.

• Do not place the system in an inclined position.
• Do not place the system in locations where it is:

— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight.

• Although the system heats up during operation, this

is not a malfunction.

• Place the system in a location with adequate

ventilation to prevent heat build up in the system.

• If you continuously use this system at a large

volume, the cabinet temperature of the top, side and
bottom rises considerably. To avoid burning
yourself, do not touch the cabinet.

• To prevent a malfunction, do not cover the

ventilation hole for the cooling fan.

Tab of side B

Tab of side A

Break off the
cassette tab
of side A