Sony CMT-DH7BT Manual

CMT-DH7BT.GB.3-097-195-11(2)

 Do not place the system in an inclined 

position or in locations that are extremely 

hot, cold, dusty, dirty, or humid or lacking 

adequate ventilation, or subject to vibration, 

direct sunlight or a bright light.

 Be careful when placing the unit or speakers 

on surfaces that have been specially treated 

(for example, with wax, oil, polish) as 

staining or discoloration of the surface may 

result.

 If the system is brought directly from a cold 

to a warm location or is placed in a very 

damp room, moisture may condense on the 

lens inside the DVD player, and cause the 

system to malfunction. In this situation, 

remove the disc, and leave the system turned 

on for about an hour until the moisture 

evaporates.

 Heat buildup on the unit during operation is 

normal and is not cause for alarm.

 Do not touch the cabinet if it has been used 

continuously at a high volume because the 

cabinet may have become hot.

 Do not obstruct the ventilation holes.

The front speaker is magnetically shielded and 

can be installed near a TV. Color irregularity 

may still be observed, however on some types 

of TV screens. In this situation, turn off the 

TV, wait 15 to 30 minutes, and turn it back 

on. Place the right speaker on the right side of 

the unit and the left speaker on the left side of 

the unit. If there is no improvement, move the 

speakers far away from the TV. 

Caution: If you leave a still video image 

or on-screen display image displayed on 

your TV for an extended period of time via 

this system, you risk permanent damage 

to your TV screen. Projection TVs are 

especially susceptible to this.

Clean this system with a soft cloth slightly 

moistened with a mild detergent solution. 

Do not use any type of abrasive pad, scouring 

powder, or solvent, such as thinner, benzine, 

or alcohol. 

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL 

HARMONIC DISTORTION:

With 6 ohm loads, both channels driven, 

from 120 – 10,000 Hz; rated 50 watts per 

channel minimum RMS power, with no 

more than 10% total harmonic distortion 

from 250 milliwatts to rated output.

DIN power output (rated):

40 W + 40 W (6 ohms at 1 kHz, DIN)

Continuous RMS power output (reference):

50 W + 50 W (6 ohms at 1 kHz, 10% 

THD)

Inputs:

AUDIO IN (stereo mini jack):

Voltage 620 mV, impedance 

47 kilohms 

Outputs:

DIGITAL OUT (square optical connector 

jack):

Wavelength 660 nm

VIDEO OUT (phono jack):

Max. output level 1 Vp-p, unbalanced, 

Sync. negative load impedance 

75 ohms

COMPONENT VIDEO OUT:

Y: 1 Vp-p, 75 ohms

Pb/Cb: 0.7 Vp-p, 75 ohms

Pr/Cr: 0.7 Vp-p, 75 ohms

S VIDEO OUT (4-pin/mini-DIN jack):

Y: 1 Vp-p, unbalanced, Sync. negative

C: 0.286 Vp-p, load impedance 

75 ohms

PHONES (stereo mini jack):

accepts headphones of 8 ohms or 

more