Sony LBT-LX6 User Manual

Connect a 6 to 15 meter (20 to 50 feet)
insulated wire to the AM antenna terminal.
Leave the supplied AM loop antenna
connected.

Jack type A

If you connect an outdoor antenna, connect a
ground wire to the U terminal with the screw
clamp. To prevent a gas explosion, do not
connect the ground wire to a gas pipe.

Insulated wire (not supplied)

Jack type B

Insulated wire (not supplied)

AM

FM  75

AM

COA

XIAL

FM   75

Before operating the system, check that the
operating voltage of your system is identical with
the voltage of your local power supply.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the
wall outlet, even if the unit itself has been turned
off.

• Unplug the system from the wall outlet (mains) if

it is not to be used for an extended period of time.
To disconnect the cord (mains lead), pull it out by
the plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

component, unplug the stereo system and have
the component checked by qualified personnel
before operating it any further.

• The AC power cord must be changed only at a

qualified service shop.

• Place the stereo system in a location with adequate

ventilation to prevent heat build-up in the stereo
system.

• Do not place the system in an inclined position.
• Do not place the system in locations where it is;

— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight

• If the stereo system is brought directly from a cold

to a warm location, or is placed in a very damp
room, moisture may condense on the lens inside
the CD player. Should this occur, the system will
not operate properly. Remove the CD and leave
the system turned on for about an hour until the
moisture evaporates.

• When you move the system, take out any discs.

If you have any questions or problems concerning
your stereo system, please consult your nearest
Sony dealer.