Garmin 310 User Manual

nüvi 310/360 Owner’s Manual

PPENDIX

FCC Compliance

The nüvi 310/360 complies with Part 15 of

the FCC interference limits for Class B digital

devices FOR HOME OR OFFICE USE. These

limits are designed to provide more reasonable

protection against harmful interference in a

residential installation, and are more stringent

than “outdoor” requirements.
Operation of this device is subject to the

following conditions: (1) This device may not

cause harmful interference, and (2) this device

must accept any interference received, including

interference that may cause undesired operation.
This equipment generates, uses, and can

radiate radio frequency energy and may cause

harmful interference to radio communications

if not installed and used in accordance with the

instructions. However, there is no guarantee

that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which

can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the

equipment and the receiver.

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

The nüvi does not contain any user-serviceable

parts. Repairs should only be made by an

authorized Garmin service center. Unauthorized

repairs or modiﬁcations could result in permanent

damage to the equipment, and void your warranty

and your authority to operate this device under

Part 15 regulations.

Declaration of Conformity

Hereby, Garmin declares that this nüvi 310/360

product is in compliance with the essential

requirements and other relevant provisions of

Directive 1999/5/EC.
To view the full Declaration of Conformity, see

the Garmin Web site for your Garmin product:

and then select the Declaration of Conformity.