Kenwood XD-502 User Manual

XD-SERIES (En)

1.The mains plug contains a fuse. For replacement, use only

a 13-Amp ASTA-approved (BS1362) fuse.

2.The fuse cover must be refitted when replacing the fuse in

the moulded plug.

3.Do not cut off the mains plug from this equipment. If the

plug fitted is not suitable for the power points in your home
or the cable is too short to reach a power point, then obtain
an appropriate safety approved extension lead or adapter,
or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse
and dispose of the plug immediately, to avoid a possible
shock hazard by inadvertent connection to the mains
supply.

IMPORTANT: The wires in the mains lead are coloured in

accordance with the following code:
Blue

: Neutral

Brown

: Live

Do not connect those leads to the earth terminal of a three-
pin plug.

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-
TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN
THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK
OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER
TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS
IN THE  LITERATURE ACCOMPANYING THE APPLIANCE.

The AC voltage selector switch on the rear panel is set to
the voltage that prevails in the area to which the unit is
shipped.  Before connecting the power cord to your AC
outlet, make sure that the setting position of this switch
matches your line voltage.  If not, it must be set to your
voltage in accordance with the following direction.

Move switch lever to match your line voltage with a
small screwdriver or other pointed tool.

Our warranty does not cover damage caused by exces-
sive line voltage due to improper setting of the AC
voltage selector switch.

The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a weaker class. There is no danger of
hazardous radiation outside the unit.