Kenwood DMF-3020 User Manual

DMF-5020/DMF-3020/MD-203 (En)

: All minidiscs contain a Table of Contents (TOC) in addition to sound signals. The TOC is similar to the table of contents in a book and

contains information, such as track numbers, track length, and character information, that cannot be rewritten.

W

*2 

: In addition to the TOC, minidiscs also contain a special User’s Table of Contents (UTOC) that contains track number, track length, and

character information, that can be rewritten.

W

÷ The cords are connected erroneously.

÷ No disc has been loaded.

÷ A non-recorded disc has been loaded.

÷ Output level is low.

÷ The disc is write-protected.

÷ An attempt is made to record digital signal from

a source while its digital copy has been prohib-
ited by SCMS.

÷ The recording level is too low (in case of analog

recording).

÷ A playback-only disc has been loaded.

÷ The disc does not have a recordable area.

÷ The REC INPUT key is not set to the actual input

source.

÷ If the amplifier is connected to this unit through

a system control cord, the amplifier’s input
selector is set to the MD input.

÷ The recording level has not been adjusted.

÷ A disc in which distorted sound has been re-

corded is played.

÷ An external noise is induced.

÷ The POWER key is set to OFF.

÷ Connect the cords in accordance with “System

connections”.

0

÷ Load a disc.

÷ Load a prerecorded disc or playback-only disc.

÷ Adjust with the OUTPUT LEVEL keys.

@

÷ Change the position of the write protect tab to

the write position or use a recordable disc.

8

÷ Use analog recording.

¶

÷ Adjust the recording level again.

•

÷ Use a recordable disc.

÷ Use another disc.

÷ Set it according to the actual input source.

¶ª

÷ Set the amplifier’s input selector to other posi-

tion than MD.

÷ Adjust the recording level.

•

÷ Use another disc.

÷ Install the unit at a position apart from an elec-

tric appliance or TV set.

÷ Set the POWER key to on (STANDBY).