JVC MX-KA5JW User Manual
26
English
Troubleshooting
• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
Symptom
Possible Cause
Action
No sound is heard.
• Connections are incorrect, or loose.
• Headphones are connected.
• Check all connections and make cor-
rections. (See pages 4 to 6.)
• Disconnect the headphones.
Poor radio reception
• The antenna is disconnected.
• The AM Loop Antenna is too close
• The AM Loop Antenna is too close
to the System.
• The FM Wire Antenna is not prop-
erly extended and positioned.
• Reconnect the antenna securely.
• Change the position and direction of
• Change the position and direction of
the AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
The disc tray does not open.
• The AC power cord is not plugged in.
• Tray is locked.
• Tray is locked.
• Plug the AC power cord.
• Unlock the tray. (See page 15.)
• Unlock the tray. (See page 15.)
The CD skips.
The CD is dirty or scratched.
Clean or replace the CD. (See page 25.)
The CD does not play.
The CD is upside down.
Put the CD in with the label side up.
The cassette holder cannot be opened.
During tape playing, the power cord
was unplugged.
was unplugged.
Plug in the power cord, and turn on the
System.
System.
Unable to record.
Cassette record protect tabs are re-
moved.
moved.
Cover holes on back edge of cassette
with tape.
with tape.
Unable to operate the Remote Control.
• The path between the Remote Con-
trol and the sensor on the Unit is
blocked.
blocked.
• The batteries have lost their charge.
• Remove the obstruction.
• Replace the batteries.
Operations are disabled.
The built-in microprocessor has mal-
functioned due to external electrical in-
terference.
functioned due to external electrical in-
terference.
Unplug the System then plug it back in.
Specifications
Amplifier
Output Power 80 W per channel, min. RMS, driven into
6
Ω at 1kHz, with no more than 10 % to-
tal harmonic distortion
Input Sensitivity/Impedance (1 kHz)
AUX IN 300 mV/50 k
Ω
Speaker terminals 6 - 16
Ω
Phones 32
Ω - 1 kΩ,
15 mW/ch output into 32
Ω
Cassette Deck Section
Frequency Response
Type I (NORMAL) 63 Hz - 12 500 Hz
Wow And Flutter 0.15 % (WRMS)
CD Player
CD Capacity 3 CDs
Dynamic Range 85 dB
Signal-To-Noise Ratio 85 dB
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.5 - 108.0 MHz
AM Tuner
Tuning Range 530 - 1 710 kHz
Unit
Dimensions 267 mm
✕
305 mm
✕
433 mm (W/H/D)
Mass Approx. 7.5 kg
Speaker Specifications (each unit)
SP-MXKA5
Type 3-way bass-reflex type
Speaker Unit Woofer: 13.5 cm cone
✕
1
Mid:
5 cm cone
✕
1
Tweeter: 2 cm dome
✕
1
Power Handling Capacity 80 W
Impedance 6
Ω
Frequency Range 45 Hz - 22 000 Hz
Sound pressure level 89 dB/w·m
Dimensions 228 mm
✕
316 mm
✕
258 mm (W/H/D)
Mass Approx. 3.1 kg
Accessories
AM Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Power Specifications
Power Requirements AC 120 V
, 60 Hz
Power Consumption 125 W (power on mode)
17 W (in Standby mode)
Design and specifications are subject to change without notice.
MX-KA5(JW)_Eng.book Page 26 Thursday, March 20, 2003 11:40 AM